Range Rover (LM) V8-4.4L (2009)
3. Install the brake fluid reservoir.
Brake Master Cylinder - Vehicles With: High Performance Brakes
Brake Master Cylinder - Vehicles With: High Performance Brakes
Service Repair No - 70.30.08
Removal
1. Remove the brake fluid reservoir.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
Remove the brake master cylinder.
^
Disconnect the 3 brake pipes.
^
Remove and discard the 2 nuts.
^
Remove and discard the seal.
Installation
WARNING: Make sure that new nuts are installed.
1. Install the brake master cylinder.
^
Clean the component mating faces.
^
Install a new seal.
^
Tighten the nuts to 26 Nm (19 ft. lbs.).
NOTE: Remove and discard the blanking caps.
2
Connect the brake pipes.
^
Tighten the nuts to 14 Nm (10 ft. lbs.).
3. Install the brake fluid reservoir.