Range Rover (LM) V8-4.4L (2009)
Parking Brake Actuator: Service and Repair
Parking Brake Actuator
Service Repair No - 70.35.48
Removal
CAUTION: It is essential that absolute cleanliness is observed when working on the parking brake actuator. Always cover any open orifices
using lint free non-flocking material to prevent the ingress of foreign matter. Failure to follow this instruction may result damage to the
components.
NOTE: It is not necessary to carry out the parking brake shoe 'bedding-in procedure' if the rear brake discs or parking brake shoes have been removed
for access to other components.
1. Release the electronic parking brake.
2. Using the Land Rover approved diagnostic system, drive the parking brake to the mounting position.
3. Using the Land Rover approved diagnostic system, depressurize the air suspension.
4. Disconnect the battery ground cable.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
5. Raise and support the vehicle.
6. Remove the rear wheels and tires.
7. Remove the RH rear fender splash shield.
^
Remove the 4 screws.
^
Remove the nut.
^
Remove the scrivet.
^
Remove the clip.
^
Disconnect the tire pressure antenna electrical connector.
NOTE: Note the routing of the parking brake emergency release cable.
8. Release the parking brake emergency release cable and rear suspension spring air lines.
^
Release the parking brake emergency release cable.
^
Release from the 2 clips.