Range Rover (LM) V8-4.4L (2009)
CAUTION: Make sure that the area around the component is clean and free of foreign material.
CAUTION: It is imperative that no damage is caused to the electrical connector or the module.
CAUTION: Do not touch the electrical connections.
26. Disconnect the parking brake actuator electrical connector.
27. Remove the parking brake actuator and cable assembly.
^
Release the 2 front rubber mounts.
Installation
1. Install the parking brake actuator and cable assembly.
^
Attach the 2 front rubber mounts.
2. Connect the parking brake actuator electrical connector.
CAUTION: Do not touch the electrical connections.
3. Install the parking brake actuator bolts and tighten to 9 Nm (7 ft. lbs.).
NOTE: Right-hand shown, left-hand similar.
4. Install the parking brake cable to the rear subframe clip.
NOTE: Right-hand shown, left-hand similar.
5. Install the parking brake cable clip to the upper suspension arm.
^
Install the bolt.
6. Connect the differential case breather line.
7. Attach the parking brake emergency release cable and rear suspension spring air lines.
^
Secure in the 2 clips.
8. Raise the rear subframe and locate on the dowels.
^
Install the spacers to the rear subframe mountings.