Range Rover (LM) V8-4.4L (2009)
WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
1. Install the parking brake shoe expander.
^
Clean the component mating faces.
NOTE: Apply grease of the correct specification sparingly to the adjuster threads.
2. Install the parking brake shoe adjuster.
^
Clean the adjuster and set it to its minimum extension.
^
Install the parking brake shoe lower return spring.
^
Assemble the parking brake shoes.
3. Install the parking brake shoes.
^
Clean the component mating faces.
^
Install both parking brake shoe retainers.
^
Install the parking brake shoe upper return spring.
CAUTION: Brake discs must be renewed in pairs.
4. Install the rear brake disc.
^
Make sure that the rear brake disc and hub mating surfaces are clean.
^
Tighten the Allen screw to 16 Nm (12 ft. lbs.).
5. Install the brake caliper.
^
Clean the component mating faces.
^
Tighten the new bolts to 15 Nm (11 ft. lbs.). plus a further 60 degrees.
6. Repeat the above procedure for the other side.
7. Adjust the parking brake shoes.
8. Install the rear wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
9. Connect the battery ground cable.