landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Electronic Brake Control Module|Locations|Page 4396 > < Electronic Brake Control Module|Locations|Page 4394
Page 3
background image

^

An HDC switch.

^

A stoplamp switch.

^

Four wheel speed sensors.

^

A yaw rate and lateral acceleration sensor.

^

A steering angle sensor.

^

Four warning indicators.

^

A HCU (hydraulic control unit) with attached ABS (anti-lock brake system) module.

ABS MODULE

The ABS (anti-lock brake system) module controls the brake functions using the HCU (hydraulic control unit) to modulate hydraulic pressure to the
individual wheel brakes.
The ABS (anti-lock brake system) module is attached to the HCU (hydraulic control unit), on the driver side inner fender in the engine compartment.
A 46 pin connector provides the electrical interface between the ABS (anti-lock brake system) module and the vehicle wiring.

ABS Module Harness Connector C1585

Electronic Brake Control Module|Locations|Page 4396 > < Electronic Brake Control Module|Locations|Page 4394