Range Rover (LM) V8-4.4L (2009)
Coolant Outlet: Service and Repair
Coolant Manifold
Service Repair No - 26.30.64
Removal
CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
3. Drain the cooling system.
4. Remove the cooling fan.
5. Remove the cooling fan drive belt.
^
Using a 1/2 inch square drive bar, rotate the drive belt tensioner clockwise.
6. Remove the throttle body gasket.
7. Position the throttle body aside for access.
^
Disconnect the TP sensor electrical connector.
^
Release the coolant manifold throttle body electrical harness clip.
8. Disconnect the coolant manifold to radiator hose.
^
Remove the clip.
9. Disconnect the thermostat housing to radiator hose.
^
Remove the clip.
10. Disconnect the transmission cooler hoses.
^
Release the clip.
^
Remove the clip.