Range Rover (LM) V8-4.4L (2009)
11. Remove the coolant manifold EGR valve hose.
^
Release the clip.
12. Disconnect both coolant manifold heater hoses.
^
Release the 2 clips.
13. Release the coolant manifold.
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug
any open connections to prevent contamination.
^
Remove the 4 Torx screws.
^
Remove and discard the 3 O-ring seals.
14. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
15. Remove the coolant manifold.
16. NOTE: Do not disassemble further if the component is removed for access only.
Remove the ECT sensor.
^
Remove the clip.
^
Remove and discard the O-ring seal.
17. Remove the thermostat housing.
^
Remove the 3 bolts.
^
Discard the O-ring seal.