Range Rover (LM) V8-4.4L (2009)
Installation
1. Install the thermostat housing.
^
Clean the components.
^
Install a new O-ring seal.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
2. Install the ECT sensor.
^
Clean the component mating faces.
^
Install a new O-ring seal.
^
Secure with the clip.
3. Connect the ECT sensor electrical connector.
4. NOTE: Lubricate the center seal with coolant to aid assembly.
Install the coolant manifold.
^
Clean the components.
^
Install new O-ring seals.
^
Tighten the Torx screws to 10 Nm (7 ft. lbs.).
5. Connect the remaining coolant hoses.
^
Secure with the clips.
6. Install the throttle body gasket.
7. Install the cooling fan drive belt.
8. Remove the cooling fan.
9. Connect the battery ground cable.
10. Refill and bleed the cooling system.