Range Rover (LM) V8-4.4L (2009)
CAUTION: The intake camshaft sprocket retaining bolt MUST be tightened before the exhaust camshaft sprocket retaining bolt. Engine
damage will occur if this procedure is not followed.
CAUTION: Make sure that new bolts are installed.
28. Install the special tool to the RH exhaust camshaft sprocket.
^
Tighten the intake camshaft sprocket retaining bolt to 20 Nm + 90 deg.
^
Tighten the exhaust camshaft sprocket retaining bolt to 20 Nm + 90 deg.
29. Install the RH VCT oil control unit.
^
Install the new O-ring seals.
^
Tighten the new bolts to 22 Nm (16 ft. lbs.).
30. Remove the special tool from the RH cylinder head.
^
Remove the 3 bolts.
31. Remove the crankshaft locking tool.
^
Remove the screw.
32. Install the CKP sensor.
33. Install the engine front cover.
34. Connect the battery ground cable.