Range Rover (LM) V8-4.4L (2009)
CAUTION: The intake camshaft sprocket retaining bolt MUST be tightened before the exhaust camshaft sprocket retaining bolt. Engine
damage will occur if this procedure is not followed.
CAUTION: Using the special tool, apply force to the tool in a counter-clockwise direction, to tension the primary timing chain on its drive side.
22. Install the special tool to the exhaust camshaft sprocket.
^
Tighten the intake camshaft sprocket retaining bolt to 120 Nm (88 ft. lbs).
^
Tighten the exhaust camshaft retaining bolt to 120 Nm (88 ft. lbs).
23. Remove the special tool from the RH cylinder head.
24. Install the RH VCT oil control unit.
^
Install the new O-ring seals.
^
Tighten the new bolts to 22 Nm (16 ft. lbs).
25. Remove the crankshaft setting tool.
^
Remove the screw.
26. Install the CKP sensor.
27. Install the engine front cover.
28. Connect the battery ground cable.