Range Rover (LM) V8-4.4L (2009)
Install the valve cover.
^
Clean the component mating faces.
5. Install the valve cover retaining bolts.
^
Install valve cover retaining bolts to their position previously noted.
^
Complete the tightening sequence as illustrated.
^
Tighten the bolts to 12 Nm (9 ft. lbs.).
6. Connect the VCT oil solenoid electrical connector.
7.
CAUTION: Lubricate the new seals with clean refrigerant oil.
Connect the A/C compressor low pressure line.
^
Install a new O-ring seal.
^
Tighten the Allen bolt to 10 Nm (7 ft. lbs.).
8. Connect the fuel line to the fuel rail.
^
Clean the component mating faces.
^
Secure the clip.
9. Attach the engine wiring harness to the retaining bracket.
10. Install the engine cover mounting bracket.
^
Secure the KS electrical connector.
11. Install the coolant hoses.
^
Connect the heater coolant hoses.
^
Tighten the nuts to 6 Nm (4 ft. lbs.).
12. Install the purge valve assembly.
13. Install the ignition coil-on-plug.
14. Install the remaining ignition coil-on-plugs.
15. Install the oil level indicator and tube.
16. Install the air intake resonator.
17. Recharge the A/C system.
18. Connect the battery ground cable.