Range Rover (LM) V8-4.4L (2009)
Drive Belt Tensioner: Service and Repair
Cooling Fan Belt Tensioner
Cooling Fan Belt Tensioner
Service Repair No - 26.25.02
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
3. Remove the radiator splash shield.
4. Release the cooling fan belt.
^
Rotate the cooling fan belt tensioner clockwise.
5. Remove the cooling fan belt tensioner.
6. NOTE: Do not disassemble further if the component is removed for access only.
Remove the cooling fan belt tensioner pulley.
^
Remove the bolt.
Installation
1. Install the cooling fan belt tensioner pulley.
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
2. Install the cooling fan belt tensioner.
^
Tighten the bolt to 40 Nm (30 ft. lbs.).
3. Secure the cooling fan belt.
WARNING: Make sure the cooling fan belt is correctly aligned to the pulleys. Failure to follow this instruction may result in damage to