Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-693006.png)
^
Evenly and progressively tighten the bolts to 20 Nm (15 ft. lbs.).
8. Connect the MAP sensor electrical connector.
9. Connect the fuel temperature sensor electrical connector.
10. Connect the brake booster vacuum hose.
11. Connect the fuel injector electrical connectors.
12. Secure the engine wiring harness.
^
Position and secure the clips.
^
Install the bolts and tighten to 10 Nm (7 ft. lbs.).
13. Install the EGR valve.
^
Install a new gasket.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
WARNING: After carrying out repairs, the fuel system must be checked visually for leaks. Failure to follow this instruction may result in
personal injury.
14. Connect the fuel line to the fuel rail.
^
Clean the component mating faces.
^
Position the fuel pipe into clips.
15. Install the engine cover mounting brackets.
^
Tighten the nuts to 6 Nm (4 ft. lbs.).
^
Attach the wiring harness connector blocks to the brackets.
16. Install the heater hose support bracket.
^
Tighten the nuts to 10 Nm (7 ft. lbs.).
17. Connect the heater coolant hoses.
^
Remove the hose clamps.
18. Connect the crankcase vent hoses.
^
Clean the component mating faces.
19. Install the throttle body.
20. Connect the throttle body electrical connector.
21. Install the purge valve.
22. Install the plenum chamber.
23. Connect the battery ground cable.
24. Check and top-up the coolant if required.
