Range Rover (LM) V8-4.4L (2009)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Rear Seal
Service Repair No - 12.21.20
Special Service Tools
Removal
1. Disconnect the battery ground cable.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
2. Raise and support the vehicle.
3. Remove the torque converter flexplate.
4. Install the special tools.
^
Install the 2 bolts.
^
Tighten the 2 nuts to retain the special tool.
5. Using the special tool, pierce the seal to create holes for the 6 self-tapping screws.
6. Using the special tools, remove and discard the crankshaft rear oil seal.
^
Install the 6 self-tapping screws.
^
Adjust the 2 nuts.
^
Tighten the center bolt.