Range Rover (LM) V8-4.4L (2009)
Installation
CAUTION: Do not lubricate the components.
1. Partially install the crankshaft rear oil seal.
^
Make sure the components are clean and dry.
^
Carefully remove the transit sleeve, leaving the seal on the crankshaft.
CAUTION: Make sure the seal is installed parallel
2. Using the special tool, install the crankshaft rear oil seal.
^
Tighten the special tool nuts evenly and progressively to fully install the seal.
3. Install the torque converter flexplate.
4. Check and top-up the engine oil.
5. Connect the battery ground cable.