Range Rover (LM) V8-4.4L (2009)
2. Connect the EGR pipe and exhaust manifold flanges.
^
Install a new gasket.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
3. Install the LH front side member exhaust heat shield.
^
Tighten the nuts.
Left-hand drive vehicles
4. Attach the lower steering column.
^
Make sure that the steering gear tag is aligned correctly, as shown.
^
Install anew Torx bolt and tighten to 24 Nm (18 ft. lbs.).
All vehicles
5. Install the engine compartment LH heat shield.
^
Tighten the screws.
^
Tighten the nuts.
6. Install the A/C compressor and the A/C compressor mounting bracket.
^
If a new compressor is being installed, the required amount of refrigerant oil must be drained from it.
7. Secure the A/C compressor mounting bracket.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
8. Secure the A/C compressor.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
9. Connect the A/C clutch electrical connector.
CAUTION: Lubricate the new seals with clean refrigerant oil.
10. Connect the refrigerant lines.
^
Clean the component mating faces.
^
Install the new O-ring seals.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
11. Secure the transmission cooler pipes into clips.
12. Install the power steering pump.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
13. Connect the high pressure line.
^
Clean the component mating faces.
^
Install the new O-ring seals.
^
Tighten the union to 25 Nm (18 ft. lbs.).
14. Connect the low pressure line.