Range Rover (LM) V8-4.4L (2009)
13. Remove the exhaust manifold.
^
Remove and discard the 8 bolts.
^
Remove the gasket/heat shield retaining bolt.
^
Discard the gasket/heat shield.
Installation
All vehicles
1. Install the exhaust manifold.
^
Clean the component mating faces.
^
Install the gasket/heat shield and tighten the bolt to 10 Nm (7 ft. lbs.).
^
Install, and lightly tighten the bolts.
^
Evenly and progressively, tighten the bolts in the sequence shown to 20 Nm (15 ft. lbs.).
2. Install the exhaust manifold heat shield.
^
Tighten the screws.
3. Attach the exhaust hangers.
4. Position the RH catalytic converter to the exhaust manifold.
^
Clean the components.
^
Tighten the new nuts to 20 Nm (15 ft. lbs.).
5. Position the LH catalytic converter to the exhaust manifold.
^
Clean the components.
^
Tighten the new nuts to 20 Nm (15 ft. lbs.).
6. Install the starter motor heat shield.
^
Tighten the bolts to 45 Nm (33 ft. lbs.).
Right-hand drive vehicles