Range Rover (LM) V8-4.4L (2009)
NOTE: LHD illustration shown, RHD is similar.
5. Remove the passenger side closing trim panel.
-
Remove the 3 screws.
-
Disconnect the footwell lamp electrical connector.
All vehicles
6. Remove the defrost vent blend door actuator.
-
Disconnect the electrical connector.
-
Release the clip.
Installation
All vehicles
1. Install the defrost vent blend door actuator.
-
Connect the electrical connector.
Left-hand drive vehicles
2. Install the driver side closing trim panel.
-
Connect the electrical connectors.
-
Attach the vehicle diagnostic socket.
3. Secure the driver side closing trim panel.
-
Install the screws.
-
Install the clip.
4. Install the driver side floor console extension.
-
Secure the clips.
-
Install the screw.
Right-hand drive vehicles
5. Install the passenger side closing trim panel.
-
Connect the footwell lamp electrical connector.
-
Install the screws.