Range Rover (LM) V8-4.4L (2009)
NOTE: Do not disassemble further if the component is removed for access only.
3. Remove the hazard flasher switch.
Installation
1. Install the hazard flasher switch.
2. Install the center registers.
-
Attach the temperature blend door control cable.
-
Connect the 4 electrical connectors.
-
Position and secure the clips.
Driver Side Register
DRIVER SIDE REGISTER
Removal
1. Remove the driver side register.
-
Carefully release the 4 internal clips, apply an even outward pressure until the last clip is released.
-
Disconnect the electrical connector.
CAUTION: Care must be taken to avoid damaging the driver side register internal components.
NOTE: Left-hand shown, right-hand similar.