Range Rover (LM) V8-4.4L (2009)
Blower Motor Resistor: Service and Repair
Blower Motor Resistor - LHD
Blower Motor Resistor - LHD
Removal
WARNING:
-
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
-
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
-
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
-
The correct procedures must always be used when working on SRS components.
-
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
-
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
-
Take extra care when handling SRS components.
1. Disconnect the battery ground cable.
2. Remove the lower glove compartment.
3. Remove the right-hand footwell duct.
-
Remove the screw.
4. Disconnect the blower motor resistor electrical connector.
5. Remove the blower motor resistor.
-
Release the retaining clip.
Installation
1. Install the blower motor resistor.
2. Connect the blower motor resistor electrical connector.
3. Install the right-hand footwell duct.
-
Install the screw.
4. Install the lower glove compartment.
5. Connect the battery ground cable.