Range Rover (LM) V8-4.4L (2009)
-
Tighten the bolts to 6 Nm (4 lb.ft).
2. Install the thermostatic expansion valve cover.
-
Install the 4 screws.
-
Secure the wiring harness to the tangs.
Right-hand drive vehicles
3. Install the right-hand front footwell duct.
-
Install the screws.
4. Install the driver side closing trim panel.
-
Connect the electrical connectors.
-
Attach the vehicle diagnostic socket.
5. Secure the driver side closing trim panel.
-
Install the screws.
-
Install the clip.
Left-hand drive vehicles
6. Install the passenger side closing trim panel.
-
Connect the electrical connector.
-
Install the screws.
7. Install the passenger side footwell duct.
-
Install the screw.
NOTE: LH illustration shown, RH is similar.
8. Install the floor console extension trim panel.
-
Secure the clips.
-
Install the screw.
9. Connect the A/C pipes.
-
Remove the blanking caps from the ports.
-
Clean the component mating faces.
-
Lubricate and install the new O-rings.
-
Install the A/C pipes.
-
Tighten the bolts to 6 Nm (4 lb.ft).
10. Recharge the A/C system.
11. Install the plenum chamber.
12. Disconnect the battery ground cable.