Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2464001.png)
Passenger Compartment Cross Beam: Service and Repair
In-Vehicle Crossbeam
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
The correct procedures must always be used when working on SRS components.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Take extra care when handling SRS components.
1. Make the air bag supplemental restraint system (SRS) safe.
2. Disconnect the battery ground cable.
3. Remove the plenum chamber.
4. Recover the air conditioning (A/C) refrigerant.
5. Remove the instrument panel reinforcement.
6. Release the battery positive cable.
^
Remove the nut.
7. Remove the plenum chamber support.
^
Remove the 3 bolts.
^
Remove the 2 nuts.
8. Using 3 suitable pipe clamps, clamp the 3 heater core coolant hoses.
9. CAUTION: Make sure that all openings are sealed. Use new blanking caps.
Disconnect the 3 heater core coolant hoses.
^
Position a container to collect the fluid spillage.
^
Release the 3 clips.
^
Install blanking caps to the exposed ports.
