Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-2485001.png)
Instrument Cluster / Carrier: Service and Repair
Instrument Panel Reinforcement
Instrument Panel Reinforcement
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
The correct procedures must always be used when working on SRS components.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Take extra care when handling SRS components.
1. Make the air bag supplemental restraint system (SRS) safe.
2. Disconnect the battery ground cable.
3. Remove the lower center registers panel assembly.
4. Remove the 4 screws securing the integrated control panel (ICP) bracket to the instrument panel reinforcement.
5. Remove the ICP assembly.
^
Disconnect the 3 electrical connectors.
^
Disconnect the 3 coaxial cables.
6. Remove the transponder coil from the ignition switch.
^
Disconnect the electrical connector.
7. Release the ignition switch from the ignition switch mounting bracket.
^
Remove the 2 screws.
8. Remove the clockspring.
9. Remove the steering column extension gaiter.
^
Release the 4 clips.
