Range Rover (LM) V8-4.4L (2009)
23. Install the ECM cover.
-
Tighten the Torx screws.
24. Connect the battery positive cable to the junction box.
-
Tighten the nut to 25 Nm (18 lb.ft).
-
Close the cover.
25. Install the A/C compressor and the A/C compressor mounting bracket.
-
If a new compressor is being installed, the required amount of refrigerant oil must be drained from it.
26. Secure the A/C compressor mounting bracket.
-
Tighten the bolts to 25 Nm (18 lb.ft).
27. Secure the A/C compressor.
-
Tighten the bolts to 25 Nm (18 lb.ft).
28. Connect the A/C clutch electrical connector.
CAUTION: Lubricate the new seals with clean refrigerant oil.
29. Connect the refrigerant lines.
-
Clean the component mating faces.
-
Install the new O-ring seals.
-
Tighten the bolts to 10 Nm (7 lb.ft).
30. Install the power steering pump.
-
Tighten the bolts to 25 Nm (18 lb.ft).
31. Connect the power steering pump high-pressure line.
-
Clean the component mating faces.
-
Install the new O-ring seals.
-
Tighten the union to 25 Nm (18 lb.ft).
32. Connect the power steering pump supply hose.
-
Clean the component mating faces.
-
Secure with the clip.
33. Install the accessory drive belt.
-
Rotate the tensioner assembly counter-clockwise.
34. Install the front wheel.
-
Tighten the wheel nuts to 140 Nm (103 lb.ft).
35. Install the cooling fan.
36. Install the air cleaner.
37. Install the engine cover mounting brackets.
-
Tighten the nuts to 6 Nm (4 lb.ft).
-
Attach the wiring harness connector blocks to the brackets.
38. Connect the suppressor electrical connector.
39. Install the purge valve assembly.
40. Connect the battery ground cable.
Tailgate Wiring Harness