Range Rover (LM) V8-4.4L (2009)
8. Connect the fuel line to the fuel rail.
^
Clean the component mating faces.
^
Position the fuel pipe into clips.
9. Connect the crankcase vent hoses.
^
Clean the component mating faces.
10. Install the engine cover mounting brackets.
^
Tighten the nuts to 6 Nm (4 ft. lbs.).
^
Attach the wiring harness connector blocks to the brackets.
11. Install the heater hose support bracket.
^
Tighten the nuts to 10 Nm (7 ft. lbs.).
12. Check and top-up the coolant if required.
13. Install the engine cover.
14. Install the purge valve.
15. Connect the battery ground cable.