Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1923020.png)
11. Install the sun visor.
12. Install the instrument panel reinforcement.
13. Connect the battery ground cable.
Passenger Air Bag Module
Passenger Air Bag Module
Service Repair No - 76.74.02
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
The correct procedures must always be used when working on SRS components.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Take extra care when handling SRS components.
NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1. Make the air bag supplemental restraint system (SRS) safe.
2. Disconnect the battery ground cable.
3. Remove the instrument panel upper section.
4. Remove the passenger air bag module.
^
Remove the 8 nuts.
Installation
1. NOTE: Install the passenger air bag module. If the SRS component is to be replaced, the bar code of the new unit must be recorded.
Install the passenger air bag module.
^
Tighten the nuts to 8 Nm (6 ft. lbs.).
2. Install the instrument panel upper section.
3. Connect the battery ground cable.
Driver Lower Air Bag Module
Driver Lower Air Bag Module
Removal
WARNING:
