Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1923021.png)
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
The correct procedures must always be used when working on SRS components.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the
battery.
^
Take extra care when handling SRS components.
CAUTION: The driver lower air bag module is handed to the drive of vehicle.
NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1. Make the air bag supplemental restraint system (SRS) safe.
2. Disconnect the battery ground cable.
3. Remove the instrument panel lower section.
4. Remove the driver lower air bag module.
^
Remove the 10 nuts.
Installation
1. NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
Install the driver lower air bag module.
^
Tighten the nuts to 8 Nm (6 ft. lbs.).
2. Install the instrument panel lower section.
3. Connect the battery ground cable.
Side Air Bag Module
Side Air Bag Module
Service Repair No - 76.74.30
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
The correct procedures must always be used when working on SRS components.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Take extra care when handling SRS components.
1. Disconnect the battery ground cable.
2. Make the air bag supplemental restraint system (SRS) safe.
3. Remove the front door trim panel.
4. Remove the side air bag module.
^
Disconnect the electrical connector.
^
Remove and discard the 3 bolts.
