Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1933001.png)
Clockspring Assembly / Spiral Cable: Service and Repair
Clockspring
Service Repair No - 76.74.20
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
The correct procedures must always be used when working on SRS components.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
Do not probe supplemental restraint system (SRS) electrical connectors.
^
Take extra care when handling supplemental restraint system (SRS) components.
CAUTION: Do not dismantle the clockspring, it has no serviceable parts and must be replaced as a complete assembly.
NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1. Make the air bag supplemental restraint system (SRS) safe.
2. Fully extend the steering column for access.
3. Disconnect the battery ground cable.
4. Remove the steering wheel.
5. Release the steering column extension gaiter.
^
Release the 6 clips.
6. Remove the steering column lower shroud.
^
Remove the 3 screws
7. Remove the steering column upper shroud.
8. Release the clockspring.
^
Remove the 4 screws.
9. CAUTION: Do not dismantle the clockspring, it has no serviceable parts and must be replaced as a complete assembly.
Remove the clockspring.
^
Disconnect the 5 electrical connectors.
