Range Rover (LM) V8-4.4L (2009)
Side Air Bag: Service and Repair
Side Air Bag Module
Side Air Bag Module
Service Repair No - 76.74.30
Removal
WARNING:
^
Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.
^
Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
^
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
^
The correct procedures must always be used when working on SRS components.
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
^
Take extra care when handling SRS components.
1. Disconnect the battery ground cable.
2. Make the air bag supplemental restraint system (SRS) safe.
3. Remove the front door trim panel.
4. Remove the side air bag module.
^
Disconnect the electrical connector.
^
Remove and discard the 3 bolts.
Installation
1. Install the side air bag module.
^
Tighten the 3 new bolts to 9 Nm (7 ft. lbs.).
^
Connect the electrical connector.
2. Install the front door trim panel.
3. Connect the battery ground cable.