Range Rover (LM) V8-4.4L (2009)
Installation
1. Install the transmission support crossmember damper.
^
Tighten the nut and bolt to 90 Nm (66 ft. lbs.).
2. With assistance, install the transmission support crossmember.
^
Install the transmission support insulator buffers.
^
Install the spacers.
^
Tighten the bolts to 68 Nm (50 ft. lbs.).
3. Attach the catalyst monitor sensor wiring harness.
^
Secure the clips.
4. Install the transmission support insulator nut, bolt and damper.
^
Lower the transmission.
^
Tighten the bolt to 115 Nm (85 ft. lbs.).
5. Install the exhaust hanger.
^
Tighten the nut to 45 Nm (33 ft. lbs.).
6. Install the heat shields.
^
Tighten the nuts.
7. Install the exhaust system.
8. Connect the battery ground cable.