Range Rover (LM) V8-4.4L (2009)
Air Spring: Service and Repair
Front Suspension
Front Air Spring
Service Repair No - 60.21.01
Removal
NOTE:
Vehicles with high performance brakes have a damper fitted to the top of each front suspension air spring. The damper is secured with high
strength thread adhesive and must be replaced if the air spring is renewed.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the front road wheel.
3. Using the Land Rover approved diagnostic system, depressurize the air suspension.
4. Release the ABS sensor lead and brake line.
^
Release from the 3 clips.
5. LH side: Release the brake pad wear sensor lead.
^
Release from the clip.
CAUTION: Note the fitted position of the special washer.
NOTE:
Use an additional wrench to prevent the ball joint rotating.
6. Release the stabilizer bar link.
^
Remove the nut.
WARNING: Use a jack to support the hub and lower arm.
7. Release the hub from the air suspension spring.
^
Remove the 2 nuts and 2 bolts.
^
Lower the jack.