Range Rover (LM) V8-4.4L (2009)
NOTE:
Note the orientation of the rubber mounts.
11. Remove the rubber mounts.
^
Remove the electrical harness clip.
Installation
1. Install the rubber mounts.
^
Install the harness clip.
2. Install the air suspension compressor.
^
Install the air suspension compressor muffler.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
^
Install and connect the air suspension compressor inlet line.
^
Connect the electrical connector.
3. Install the air suspension compressor lower cover.
^
Position the washers.
^
Install the bolts.
4. Install the air suspension compressor assembly to the vehicle.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
5. Install the air suspension compressor lines.
^
Install the air suspension reservoir solenoid valve block.
^
Clean the component mating faces.
^
Connect the air compressor outlet line.
6. Position the electrical harness.
^
Connect and secure the electrical connectors.
CAUTION: Make sure the air suspension compressor upper cover is correctly positioned.
CAUTION: Make sure the electrical harness and air lines are not trapped.
7. Install the air suspension compressor upper cover.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
8. Install the spare wheel and tire.
^
Install the cup washer and bolt, tighten the wing nut.