Range Rover (LM) V8-4.4L (2009)
Ride Control Solenoid Valve: Service and Repair
Air Suspension Reservoir Solenoid Valve Block
Air Suspension Reservoir Solenoid Valve Block
Service Repair No - 60.50.05
Removal
1. Using T4, depressurize the air suspension.
2. Disconnect the battery ground cable.
3. Remove the air suspension pressure switch.
CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry.
Plug open connections to prevent contamination.
CAUTION: Break the Voss collet to remove, attempting to slide the collet from the air line will result in damage.
NOTE:
Note the air line fitted positions.
4. Remove the air suspension reservoir solenoid valve block.
^
Disconnect the electrical connector.
^
Release the air suspension reservoir solenoid valve block, from the compressor mounting bracket.
^
Disconnect the 3 air lines.
^
Remove and discard the Voss connector collets and unions from the air lines.
^
Remove the 3 rubber insulators.
Installation
NOTE:
New air suspension components are supplied with new Voss connectors tightened to the correct torque. Do not install new voss connectors if a
new component is being installed.
1. Install the air suspension reservoir solenoid valve block.
^
Install the rubber insulators.
^
Remove the Voss collet alignment pegs.
^
Connect the air lines.
^
Mount the air suspension reservoir valve block.
^
Connect the electrical connector.
2. Install the air suspension pressure switch.
3. Connect the battery ground cable.
4. Using T4, pressurize the air suspension.