Range Rover (LM) V8-4.4L (2009)
CAUTION: The washer is hardened and must be fitted in the correct position.
NOTE:
Use an additional wrench to prevent the component from rotating.
4. Connect the stabilizer link.
^
Install the special washer.
^
Tighten the nut to 100 Nm (74 ft. lbs.).
5. Secure ABS sensor lead and brake line.
^
Secure into the 3 clips.
6. LH side: Secure the brake pad wear sensor lead.
^
Secure in the clip.
7. Vehicles with high performance brakes: Install a new damper.
^
Clean the component mating faces.
^
Apply a 3 mm bead of high strength retainer STC 50554 to the thread.
^
Tighten to 20 Nm (15 ft. lbs.).
^
Install the cap.
CAUTION: The air springs must be fully pressurized before the weight of the vehicle is applied to them.
8. Using the Land Rover approved diagnostic system, pressurize the air suspension.
9. Install the road wheel.
^
Tighten nuts to 140 Nm (103 ft. lbs.).
10. Check, and if necessary, adjust the wheel alignment.
Rear Suspension
Rear Air Shock Absorber
Service Repair No - 64.30.02.45
Special Service Tools