Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1272001.png)
Differential Mount: Service and Repair
Axle Housing Bushing
Axle Housing Bushing - 4.2L/4.4L
Service Repair No - 51.15.43
Removal
1. Disconnect the battery ground cable.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
2. Raise and support the vehicle.
3. Remove the exhaust system.
4. Remove the fuel tank heat shield.
^
Remove the 8 screws.
CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
5. Release the driveshaft from the rear axle drive flange.
^
Remove the 6 Torx bolts and washers.
CAUTION: Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean and
dry. Plug open connections to prevent contamination.
6. Disconnect the axle case breather line.
NOTE:
Allow the axle to rotate until the drive flange hangs down.
7. Lower the rear axle assembly.
