Range Rover (LM) V8-4.4L (2009)
^
Using a transmission jack, support the axle.
^
Remove and discard the nut and bolt.
^
Remove the 2 bolts.
CAUTION: Note the fitted position of the bush and mark the sub-frame to aid assembly.
NOTE:
Move the axle case rearwards for access.
8. Using the special tools, remove the rear axle housing front bushing.
Installation
CAUTION: Lubricate the new bush with rubber lubricant to aid assembly.
CAUTION: Align the new bush to the mark on the sub-frame.
1. Using the special tools, install the rear axle housing front bushing.
^
Clean the component mating faces.
2. Install the axle assembly.
^
Clean the component mating faces.
^
Tighten the bolts to 100 Nm ( 74 ft. lbs.).
^
Tighten the new nut and bolt to 120 Nm (89 ft. lbs.), then a further 180 degrees.
3. Connect the axle case breather line.
4. Attach the driveshaft to the rear axle drive flange.
^
Clean the component mating faces.
^
Install the washers.
^
Tighten the Torx bolts to 44 Nm (32 ft. lbs.), then a further 45 degrees.
5. Install the fuel tank heat shield.
^
Tighten the screws.
6. Install the exhaust system.
7. Install the wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
8. Connect the battery ground cable.