Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1289008.png)
CAUTION: It is possible to fit the driveshaft incorrectly. The universal joint must be rearward of the center bearing when installed in the
vehicle.
NOTE:
A small amount of oil may weep from the driveshaft joints during storage. The loss of this oil will not affect the operation or durability of the
joint.
8. Attach the driveshaft to the rear axle drive flange.
^
Remove the cable tie.
^
Clean the component mating faces.
^
Align the driveshaft to the previously noted position.
^
Tighten the Torx bolts to 44 Nm (32 ft. lbs.), then a further 45 degrees.
^
Remove the cable tie.
CAUTION: Make sure the center bearing mount is not under tension and central within the slots.
9. Attach the driveshaft center bearing mount.
^
Align the center bearing mount.
^
Tighten the nuts to 21 Nm (15 ft. lbs.).
10. Install the fuel tank heat shield.
^
Tighten the screws.
11. Install the center heat shield.
^
Tighten the nuts.
12. Install the exhaust system.
CAUTION: Make sure the correct specification and quantity of oil is used.
13. Check the differential oil level and top up if necessary
