Range Rover (LM) V8-4.4L (2009)
CAUTION: Pull on the halfshaft inboard joint to make sure the clip has fully engaged and retains the halfshaft inboard joint within the
differential case.
2. Secure the halfshaft.
^
Install a new circlip.
^
Lubricate the seal.
^
Remove the halfshaft seal protector.
3. Remove the special tool.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
4. Secure the LH rear lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the rear lower arm nut and bolt to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
5. Secure the LH front lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the lower arm nut and bolt to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
6. LH side front: Secure the suspension height sensor.
7. Secure the LH tie rod end.
^
Install new nut and tighten to 80 Nm (59 ft. lbs.).
8. Secure the LH front ABS sensor and wiring harness.
^
Apply anti-seize compound to the ABS sensor.
^
Tighten the bolt to 8 Nm (6 ft. lbs.)
^
Secure in the clip.
9. Install the LH front brake disc.
10. With assistance tighten the wheel hub nut to 420 Nm (311 ft. lbs.).
^
Use a new nut.
^
Stake the nut to the halfshaft.
11. Install the LH front wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
12. Check and top-up the differential case.
13. Check, and if necessary, adjust the wheel alignment.
Halfshaft Seal RH
Halfshaft Seal RH
Service Repair No - 54.10.21
Special Service Tools