Range Rover (LM) V8-4.4L (2009)
CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
10. Using the special tool release the RH tie rod end.
^
Remove and discard the nut.
11. Position a container to collect the fluid spillage.
12. Install the special tool, to the inner halfshaft joint.
13. Release the clip.
14. RH front: With assistance, remove the halfshaft and wheel knuckle assembly.
^
Remove the 2 nuts and 2 bolts.
15. Remove and discard the clip from the RH halfshaft.
16. RH front: Remove and discard the halfshaft seal.
Installation
1. Using the special tool, install a new halfshaft seal.
^
Lubricate the seal with clean differential fluid.
2. RH front: With assistance, install the wheel knuckle.
^
Install a new circlip.
3. Secure the wheel knuckle assembly to the shock absorber and spring assembly.
^
Tighten the nuts and bolts to 250 Nm (184 ft. lbs.).