Range Rover (LM) V8-4.4L (2009)
4. Secure the RH tie rod end.
^
Install a new nut and tighten to 80 Nm (59 ft. lbs.).
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
5. Secure the RH rear lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the tie rod bolt to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
6. Secure the RH front lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the lower arm bolt to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
7. RH side front: Secure the suspension height sensor.
8. Secure the stabilizer bar links.
^
Tighten the nuts to 100 Nm (74 ft. lbs.).
9. Secure the RH front ABS sensor and wiring harness.
^
Apply anti-seize compound to the ABS sensor.
^
Tighten the bolt to 8 Nm (6 ft. lbs.)
^
Secure the clip.
10. Install the RH front brake disc.
11. Install the front wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
12. Check and top-up the differential case.
^
Remove the container.
13. Check, and if necessary, adjust the wheel alignment.