Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1351012.png)
CAUTION: Centralize the snap ring in the snap ring groove before installing the output flange.
CAUTION: Extreme care is necessary to make sure the snap ring enters the bearing squarely.
5. Using the special tool and with assistance, install the drive flange.
^
Clean the component mating faces.
^
Install a new snap ring.
^
Make sure the snap ring is fully engaged and retains the drive flange.
6. Secure the rear half of the transfer case with its rear face down on a flat surface.
NOTE:
Rotate the differential to engage the splines.
7. Install the differential module.
^
Clean the components.
^
Install the spacer.
NOTE:
