Range Rover (LM) V8-5.0L SC (2010)
14. Install the fuel tank support strap securing bolt: (Figure 6)
^
Tighten bolt to 19Nm (14 lbf ft).
15. Tighten the center bolt to 19Nm (14 lbf ft). (Figure 5)
16. Tighten the fuel tank center fixing to 19Nm (14 lbf ft).
17. Install the fuel tank shield.
^
Tighten the nuts and bolts to 25Nm (18 lbf ft). (Figure 4)
18. Install the driveshaft heat shield: (Figure 3)
^
Tighten the eight screws to 5Nm (3.5 lbf ft).
19. Secure the tailpipe: (Figure 2)
^
Tighten the two nuts to 47 Nm (35 lbf ft).
20. Lower the vehicle.
21. Install the LH fuel tank access cover: (Figure 1)
^
Tighten the four nuts to 10Nm (7lbf ft).
22. Position the carpet.
23. Attach the spare wheel removal straps:
^
Tighten the Allen bolts to 45Nm (33 lbf ft).
24. Refer to Workshop Manual, section 501-05: Interior Trim and Ornamentation, and install the LH and RH C-pillar lower trim panels.