Range Rover County LWB (LH) V8-4.2L (1993)
Idler Pulley: Recalls
Recall - Idler Pulley
01/09/95
D 871
SUBJECT:
Idler Pulley
MODEL:
Range Rover 4.0 SE
AFFECTED VEHICLES
LP 300190 to 319682
LH
LJ
LD
DETAIL
Land Rover has identified a possible defect in the engine drive belt idler pulley fitted to a number of Range Rover 4.0 SE vehicles. As a result all
vehicles within the above VIN range will have the idler pulley replaced with a revised design pulley.
ACTION REQUIRED
Carry out the procedure below on all vehicles within the above VIN range. when completed identify the completion of the recall in the owners Passport
to Service booklet.
PARTS INFORMATION
ERR6702 - Idler pulley (replaces ERR 4348)
(ERR446O - Drive Belt, if required)
PROCEDURE
1.
Remove the ignition key from the ignition lock.
2.
Remove upper fan cowl.
3.
Remove fan and viscous unit using service tool LRT-12-094. If the unit does not break free it may be necessary to use a long screw driver as a
lever to hold the water pump pulley stationary.
4.
Rotate tensioner to release tension from the drive belt. Remove the belt and inspect it for damage. Replace the belt if necessary.
5.
Remove the idler pulley ERR 4348 and discard.