Range Rover County LWB (LH) V8-4.2L (1993)
ASSEMBLING MAINSHAFT AND LAYSHAFT TO CENTRE PLATE.
1.
Secure centre plate to workstand.
2.
Fit selected shims and bearing tracks.
3.
Fit inboard detent ball and spring, use a dummy bar to temporarily hold the bail in place.
4.
Check both synchromesh units are in neutral and fit selector shaft to mainshaft.
5.
Fit mainshaft and selectors as complete unit to centre aligning pin with slot in plate.
6.
Fit 4th gear synchromesh baulk ring.
7.
Fit layshaft whilst lifting mainshaft to clear layshaft rear bearing.
8.
Lubricate pilot bearing and fit input shaft.