Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-3040002.png)
NOTE: Ensure that the badge set aligns correctly in the installation jig before the film layer is returned in place.
1. Inspect the condition of the replacement rectangular "SUPERCHARGED" badge associated with the "SPORT" badge.
2. Verify the condition of the new badge to ensure the badge is not distorted and is straight.
3. If any distortion of the new "SUPERCHARGED" badge is determined, partially remove the top surface film layer and correct the distortion.
(Figure 1)
4. Position the foam position blocks before any other action as follows:
^ Place appropriate empty installation template over nameplate badge lettering to be replaced. (Figure 2)
CAUTION: Care must be taken to position the foam location pads tight against the template to ensure accurate nameplate badge positioning.
^ Remove the backing tape from the foam location guides and position around the bottom corners of the foam template. (Figures 3)
