Range Rover Sport (LS) V8-4.2L SC (2006)
Yaw Rate Sensor: Service and Repair
Yaw Rate Sensor
Service Repair No - 70.70.35
Removal
1. Disconnect the battery ground cable.
2. Remove the floor console.
3. CAUTION: Make sure the wiring harness is protected when cutting the carpet.
Remove the yaw rate sensor
^
Cut the carpet for access.
^
Position the wiring harness aside.
^
Disconnect the electrical connector.
^
Remove the 2 bolts.
Installation
1. Install the yaw rate sensor.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
^
Connect the electrical connector.
^
Attach the wiring harness.
^
Attach the carpet.
2. Install the floor console.
3. If a new yaw rate sensor has been installed, interrogate the ABS system using T4.