Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1652002.png)
7. Disconnect the high pressure line from the power steering gear.
^
Remove the bolt.
^
Release the power steering gear line.
^
Remove and discard the O-ring seal.
8. Remove the steering gear high-pressure line.
Installation
1. Install the steering gear high-pressure line.
2. Connect the high-pressure line to the power steering gear.
^
Install the O-ring seal.
^
Attach the power steering gear high-pressure line.
^
Tighten the bolt to 25 Nm (18 lb.ft).
3. Install the power steering line support bracket.
^
Tighten the nut to 10 Nm (7 lb.ft).
^
Secure the hose with the clip.
4. CAUTION: Always plug any open connections to prevent contamination.
Connect the high-pressure line to the power steering pump.
^
Install new sealing washers.
^
Connect the power steering pump high-pressure line.
5. Install the radiator access panel.
^
Tighten the bolts to 10 Nm (7 lb.ft).
6. Install the front LH fender splash shield.
7. Install the front RH splash shield.
^
Secure with the clips.
8. Fill and bleed the power steering system.
