Range Rover Sport (LS) V8-4.4L (2009)
/v8-4.4l/Page-1809002.png)
connections to prevent contamination.
CAUTION: Make sure the actuator fluid lines are not damaged or kinked during removal or installation.
NOTE: Some fluid spillage is inevitable during this operation.
Disconnect the fluid lines from the actuator.
^
Position container to collect fluid loss.
^
Remove the 2 bolts.
^
Remove and discard the O-ring seals.
^
Remove and discard the plastic spacer washers.
^
Install blanking caps to the exposed ports.
10. CAUTION: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open
connections to prevent contamination.
NOTE: Some fluid spillage is inevitable during this operation.
Disconnect the rear actuator pipes from the valve block.
^
Position a container to collect the fluid spillage.
^
Remove and discard the nut.
11. Remove the valve block to rear stabilizer bar actuator pipe assembly.
Installation
1. Check the valve block O-rings and plastic spacer washers are correctly installed.
^
A: Backing rings (white)
^
B: Outer clamping ring
^
C: O-ring seals
^
D: Outer backing ring (Black)
2. CAUTION: Make sure the actuator fluid lines are not damaged or kinked during removal or installation.
Install the valve block to rear stabilizer bar actuator pipe assembly.
