Range Rover Classic
CRUISE CONTROL - V8i
5
REPAIR
Link - adjust
3. Remove link from actuator.
4. Rotate socket joint adjuster as necessary.
5. Refit link to actuator and recheck clearance
between link and lever.
6. With throttle fully open, check a gap of at least
3mm exists between side of link ("A" in
illustration) and side of small spring ("B" in
illustration). Realign link by bending to achieve
correct gap. Recheck clearance at closed
throttle/open throttle. Check link slides smoothly
in groove of throttle lever.
VACUUM PUMP
Service repair no - 19.75.06
NOTE: The vacuum pump is non
serviceable, fit a new unit if failure or
damage occurs.
Remove
1. Remove air cleaner.
See Air Cleaner
Assembly
2. From under the LH front wing [fender]:
Press 3 rubber mountings through panel and
release vacuum pump.
3. From inside engine compartment:
Withdraw out of panel aperture.
4. Disconnect multiplug from vacuum pump.
5. Release vacuum pump rubber mountings from
body.
6. Disconnect vacuum feed hose and remove
vacuum pump.
Refit
7. Reverse removal procedure. Ensuring all hose
and electrical connections are secure.