ES 300 V6-3.0L (1MZ-FE) (1997)
-
As there is retained pressure in the fuel pipe line, prevent it from splashing inside the engine compartment.
6. Remove delivery pipes and injectors.
NOTICE: Be careful not to drop the injectors when removing the delivery pipes.
(a) Remove the 5 bolts and delivery pipes together with the 6 injectors and fuel pipe.
(b) Remove the 4 spacers from the intake manifold.
(c) Pull out the 6 injectors from the delivery pipes.
(d) Remove the 2 O-rings and 2 grommets from each injector.
INSTALLATION
1. Install injectors and delivery pipes.
(a) Install new insulator and grommet to each injector.
(b) Apply a light coat of spindle oil or gasoline to 2 new O-rings and install them to each injector.
(c) Apply a light coat of spindle oil or gasoline on the place where a delivery pipe touches an O-ring of the injector.
(d) While turning the injector clockwise and counterclockwise, push it to the delivery pipes. Install the 6 injectors.
(e) Position the injector connector outward.
(f) Place the 4 spacers in position on the intake manifold.